Central Heating Problems?

Then a JAYSTAR power flush could be the answer

Is the system slow to warm up?
Are some radiators completely or partially cold?
Do radiators need frequent bleeding?
Is radiator water dirty and discoloured?
Radiators with pin hole perforations and leakage?
Are there 'kettling' noises from the boiler?
Do you have repeated pump failures?

Any of these symptoms could indicate that your system has circulation and flow problems resulting from internal corrosion and the subsequent formation of rust, sludge, and scale deposits.

A JAYSTAR power flush can restore circulation and efficiency to the heating system by removing these undesirable products. It purges them from the system, and replaces aggressive water with Clean water, chemically treated to prevent future problems,

Fitting a new boiler to an existing heating System?

The high efficiency and compactness of modern boilers, developed to minimise fuel costs and pollution, makes them more susceptible to problems caused by debris in the system water.

Boiler manufacturers insist that heating systems must be thoroughly flushed before installing a new boiler. A JAYSTAR power flush is far more effective than traditional methods and ensures that the boiler installation complies with 'best practice' standards

Why have your system power flushed

• Cures flow and circulation problems.
• Restores system efficiency.
• Restores heat output to radiators.
• Cleans the whole system, including underfloor pipework.
• Removes aggressive water; treatment prevents further corrosion.
• Cures or prevents boiler noise.
• Power flushing and descaling in only one visit
• Complete process carried out in less than five hours (depending on system size)
• More effective than traditional flushing methods.
• Minimises boiler warranty problems.

Note
Spring/Summertime system turn off increases settlement of sludge, scale and solidification and turn on problems at heating season start

The JAYSTAR power flushing pump is simply connected into the heating system. either across the standard circulator pump couplings, across the tails of one radiator, or wherever most practicable.

Power flushing is a highly effective cleansing operation which works by pumping water at a much higher velocity than usual through the heating system, to loosen and mobilise harmful corrosion deposits, and to suspend them in the rapidly moving water. The process is made more effective by specialist cleansing chemicals and an instantaneous flow reversal device, which creates turbulence in the radiators to optimise 'pick up' of the debris.

Once loosened, the unwanted debris is purged from the system with clean water. At the end of the flushing process, the system contains fresh clean water, and reinstatement of the system to normal operation takes only a few minutes.

During the JAYSTAR process, radiators are individually flushed, without removing or disconnecting them from the system, by directing the full output of the pump through each radiator separately.

JAYSTAR power flushing is not a high pressure operation and it is suitable for most domestic wet central heating systems. It is carried out with minimal disturbance and disruption to the normal operation of the system, often without disconnecting the boiler or any radiators.

Why do heating systems need protecting?

As soon as a heating system is completed and filled with water, deterioration of the system begins. The combination of water, air, a mixture of metals, and even installation debris and contaminants, can result in internal corrosion, sludge formation in low flow areas, and scaling of boilers and heat exchangers.

Symptoms include cold panels in radiators, blocked radiators, irritating boiler noises, a long recovery time after drawing off hot water, an inadequate water supply and failure of pumps, radiators and valves.

These problems are not inevitable, good care and maintenance of a system and addition to the heating system of a quality corrosion and scale inhibitor will prevent and often cure them.

[Home] [Who We Are] [Power Flushing] [Gas Safe] [Emergency] [Testimonials] [Contact]